Have a paint project in mind?

We can repaint your walls and ceilings, also wood trim, doors and cabinets.  We use quality materials such as: Sherwin Williams paints and stains, Benjamin Moore paints and Behr paints.

- wall and ceiling patches

- accidental bumps and holes

- water damaged areas and stains

We can repair, retexture and repaint these areas to make your areas feel clean and comfortable again.

We specialize in hand and trowell textures.  We can also do orange peel, knockdown and acoustic textures as well.  And for something really new and interesting, we can do a ShimmerStone texture which gives a metallic look to the texture which is great for feature walls, dining room or entry ceilings, bathrooms, really just about anywhere you would like.

ShimmerStone is a pre-colored, trowel applied, architectural coating that emits a symphonic blend of shimmer, luster, elegance and environmental friendliness. Metallic Plaster is mixed and color matched in the factory for consistent project results and available in 25 standard colors. It is durable, water resistant, mold & mildew resistant and will adhere to any primed surface. This lightweight water base coating applies easily and can be used to create a wide variety of decorative finishes. 

We can transform wallpapered areas and ceilings textured with popcorn or acoustic texure and replace them with a newly textured and painted surface that greatly improves the area and gives it an updated look.

Paint over Wallpaper process:

- Peel: we begin by peeling back all loose areas of the paper and backing to get to the paper that is solidly attached to the wall - if it sticks, it stays!

- Seal: we seal the area with primer which helps seal the adhesive within the paper and away from the moisture in the paint. 

- Float: then we float the seams and edges to give a smooth surface for the new texture.

- Texture: apply new preferred texture

- Paint: prime and paint to the color and sheen of your choice.

Popcorn or Acoustic Removal process:

Asbestos Check: first thing to check is if there is any asbestos in the material.  The use of asbestos in building materials was banned in 1977.  But, contractors who had already purchased materials were able to continue to use their stock until it ran out.  Consequently, asbestos could be present in houses built as late as the early '80's.  Luckily, the laboratory testing is inexpensive. 

No Asbestos process:

- Scrape: we have formulated a process of scraping popcorn that is quick and clean.  

- Float: once the popcorn is removed, the ceiling needs to be floated smooth to cover the nail/screw divots and seam tape that becomes exposed.

- Texture: apply new preferred texture

- Paint: prime and paint to the color and sheen of your choice

Asbestos Present process:

Popcorn with asbestos can only be removed with a very costly and complex process.  However, instead of removal, it can be sealed in place and covered over.

- Seal: spray gloss finish on popcorn to seal it in place

- Float: two float coats of drywall mud to cover and smooth the finish to a flat area that can be retextured

- Texture: apply new preferred texture

- Paint: prime and paint to the color and sheen of your choice

We can take those tired looking cabinets in the kitchen or bathroom and either add life back the stained finish or apply fresh paint to give the area a completely new feel and updated appearance.

Front doors get beat up by the sun and weather.  We can refurbish a stained door and give it multiple coats of Marine varnish which has UV ray inhibitors in it.  And, we could also paint or repaint your door in the color and sheen  of your choice.